How to Make Danbo Papercraft

in this post I will share about how to make danbo,,

you must know the shape danbo doll,,nah ... 

why do not we do not try to make your own,,easy way,,

it just takes patience and thoroughness ..: D 

First - we prepare all the equipment that we will use

equipment:

 - Danbo papercraft model (which is already in print)

 - Scissors 

 - Cutter

 - Glue

 - Ruler
steps to make danbo

print image below danbo models

 

1.      Cut and paste the pictures 16 piece color white glue. It is part of the arm.

2.      Cut and glue in Figure 3 upper arm created in step 1.

3.   Cut Figure 6, folding indentations, white glue to the other end with glue, so that such circular  ring. Give the glue on both the teeth and glue pieces of figure 7 on each side so as cylinders.

4.  Connect the parts are made from step 3 and step 2, thus forming a movable arm (see picture).

5.      Cut holes in figure 8 and 3 parts white. then cut figure 10. In figure 10 there are lines cross in a circle, cut it with a razor kurter line, then plug it into the big hole in the figure 8. Then fold up the whites. If this confused picture no explanation (explanation). After that cut the figure 11 and closed four white lines earlier. Try to be spinning (neck joint profit). Then cut the images 18 and 19. And do it like that. Then glue the body.

6.      Attach the arm to the left and right parts that you created in step 5 earlier.

7.    Make 2 cylinders again as step 3, but with images 14, 15. Cut 13 and connect it to the 2 cylinder before (see picture).

8.     Cut the appropriate figure 12 fold lines and glue the cylinder that was created in step 7. (See picture)

9.      Glue the result from step 8 to the upper body created in step 5 (the neck).

10. Cut Figure 1, the corresponding folding pattern. Cut also figure 4 and figure 1 the eye holes, and attach pieces of figure 4 in Figure 1 so that her eyes look more real (optional).

11.  Connect the head from step 10 to the neck made in step 9.

12.  Figure 2 Cut and glue, let the better (of the foot).

13.  Cut out pictures of 17 and 5, then create a cylinder as step 3, then pairs of legs from step 12 and try to get round.

14.  Glue both sides of the cylinder to the bottom of the body.

finish... 
I hope you can make it ....